Filter
Top Products
7
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly can be completed using the included
allen wrenches.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
3. Connect the Right Power Wire Harness (57) in the indi-
cated location. Push all of the excess wire up into the
Right Upright (95). Make sure that the Wire Harness is
fully connected.
2. While a second person holds the Handrail (91) near the
Uprights (95, 97), feed the wires in both sides of the
Handrail down into the Uprights. Pull the ends of the
wires out of the lower ends of the Uprights. If there are
wire ties on the ends of the wires, remove them.
Finger tighten eight Handrail Bolts (99) into the Uprights
(95, 97) and the Handrail (91). Do not tighten the
Handrail Bolts yet. Be careful to avoid pinching the
wires.
Note: The CD Holder (86) and the Cup Holder (85) are
replaceable. If these parts become dislodged from the
Console Base (89), simply press them back into place.
97
91
86
89
85
99
99
99
Wires
2
1. Slide the Right and Left Uprights (95, 97) onto the brack-
ets near the front of the Frame (76). Make sure that the
Uprights are on the correct sides; the indicated holes
must be facing the treadmill.
Raise the Right Upright (95) until the lower hole in the
front of the Upright is aligned with the upper hole in the
bracket. Thread an Upright Bolt (96) into the Upright and
the bracket. Do not fully tighten the Upright Bolt yet.
Repeat this step with the Left Upright (97).
95
96
96
76
97
HOW TO SET UP THE TREADMILL
57
3
Holes
1
95
95