Filter
Top Products
24
Press the ENTER AGE/WT button again to
check for system errors.
If there are no system errors, the words NO SYS-
TEM ERRORS will appear in the main display. If
the words LUBRICATE DECK appear in the main
display, the walking platform should be checked
for adequate lubricant. Follow the instructions in
step 4 on page 29 to lubricate the walking platform
if necessary. Then, refer to HOW TO RESET THE
LUBE REMINDER on this page.
Press the ENTER AGE/WT button again and
enable or disable the lubrication reminder.
The console can be set to display the words LU-
BRICATE DECK every 15 minutes when the walk-
ing platform needs to be lubricated. Press the + or
– button above the ENTER AGE/WT button until
the words LUBE REMINDER ENABLED appear in
the main display. To turn off the lubrication re-
minder, press the + or – button until the words
LUBE REMINDER DISABLED appear.
Press the ENTER AGE/WT button again and
enable or disable the safety key.
To require the use of the safety key with the con-
sole, press the + or – button above the ENTER
AGE/WT button until the words SAFETY KEY EN-
ABLED appear in the main display. To allow the
treadmill to be used without the key, press the + or
– button until the words SAFETY KEY DISABLED
appear. CAUTION: If the safety key is missing
or damaged, call Customer Care toll-free at
1-800-201-2109, Monday through Friday, 8 a.m.
until 5 p.m. Mountain Time.
Hold down the ENTER AGE/WT button and the
RESET button simultaneously for two seconds
to exit the maintenance mode.
To exit the maintenance mode at any time, hold
down the ENTER AGE/WT button and the RESET
button simultaneously for two seconds.
HOW TO RESET THE LUBE REMINDER
If the words LUBRICATE DECK appear in the main
display when the maintenance mode is selected (refer
to step 9 on this page), follow the steps below to reset
the lube reminder.
Insert the key into the console.
Refer to GETTING STARTED on page 14.
Hold down the STOP button and the RESET
button simultaneously for three seconds.
2
1
9
10
11
12