Filter
Top Products
9
9. Plug the Power Cord (55) into the power socket
at the rear of the elliptical exerciser (see HOW
TO PLUG IN THE POWER CORD on page 10).
IMPORTANT: If the elliptical exerciser has
been exposed to cold temperatures, allow it
to warm to room temperature before plug-
ging in the power cord. If you do not do this,
the console displays or other electronic
components may become damaged.
The ramp will calibrate automatically when
the elliptical exerciser is plugged in for the
first time.
9
8. Identify the Right Handlebar (31), which is
marked with a “Right” sticker and orient it as
shown. Attach the Right Handlebar to the right
Upper Body Arm (12) with two 5/16" x 1.5"
Button Bolts (73) and two 5/16" Nylon Locknuts
(106). Make sure that the Nylon Locknuts are
in the hexagonal holes.
Repeat this step to attach the Left Handlebar
(7) to the left Upper Body Arm (12).
8
31
106
73
7
12
55
12
10. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
Hexagonal
Holes
7. While a second person holds the Console (60)
near the Upright (6), connect the console wire to
the Upper Wire Harness (97). Then, connect the
console pulse wire to the Hand Pulse Wire (65).
Insert the excess wire downward into the
Upright.
Tip: Avoid pinching the wires during this
step. Attach the Console (60) to the Upright (6)
with four #8 x 3/4" Screws (78).
7
Avoid pinching the
wires during this step
Pulse Wire
6
Console Wire
65
97
78
60