Filter
Top Products
8
6. Identify the Right Link Arm (10), which is
marked with a “Right” sticker. Apply a small
amount of grease to the axles on the Right Link
Arm and to two 5/8" Wave Washers (102).
Then, slide a Pivot Spacer (71) and a Wave
Washer onto each axle.
At the same time, slide the Right Link Arm (10)
into the right Upper Body Arm (12) and into the
Right Pedal Arm (8).
Attach the Right Link Arm (10) to the right
Upper Body Arm (12) with a 5/16" x 1" Patch
Screw (81), a Large Axle Cover (94), and a
5/16" Washer (104).
Then, attach the Right Link Arm (10) to the
Right Pedal Arm (8) with a 5/16" x 1" Patch
Screw (81), a Small Axle Cover (67), and a
5/16" Washer (104).
Tip: If you have a hard time working the Link
Arms (10, 11) all the way into the Upper
Body Arms (12) and the Pedal Arms (8, 9),
try working them in halfway and then tight-
ening the 5/16" x 1" Patch Screws (81) to
pull them the rest of the way in.
Repeat this step for the other side of the
elliptical exerciser.
6
10
67
81
12
71
102
71
8
Grease
Grease
5
5. Identify the Right Pedal Assembly (62), which is
located in a package marked with a “Right”
sticker. Attach the Right Pedal Assembly to the
Right Pedal Arm (8) with five #10 x 1/2" Screws
(79) and five #10 Fender Washers (80). Tip: To
avoid damaging the Pedal, do not over-
tighten the Screws.
Repeat this step for the Left Pedal Assembly
(56).
80
62
56
79
79
8
102
104
81
104
94