Filter
Top Products
17
Inspect and properly tighten all parts of the exercise
cycle regularly. The exercise cycle can be cleaned
with a soft, damp cloth. To prevent damage to the
c
onsole, keep liquids away from the console and keep
the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced. See assembly step 5 on page 6
for replacement instructions. If the console does not
display your heart rate when you use the handgrip
pulse sensor, see step 5 on page 13.
HOW T
O LEVEL THE EXERCISE CYCLE
If the exercise cycle
does not sit flat on
your floor, turn one
or both of the level-
ing feet until the
exercise cycle is
level.
HOW TO ADJUST THE REED SWITCH
If the console does
n
ot display correct
feedback, the reed
switch should be
adjusted. First, use a
small flat screwdriver
to carefully pry off the
left Side Shield
Cover (14). Next,
rotate the left Pedal
Guard (8) and pull it away from the Left Side Shield (4).
Next, locate
the Reed
Switch (49).
Turn the Left
Crank
Arm (15)
until the
Magnet (23) is
aligned with
the Reed
Switch.
Loosen, but do
not remove,
the indicated
M4 x 16mm
Screw (54).
Slide the Reed Switch slightly closer to or away from
the Magnet. Then, retighten the Screw. Turn the Left
Crank Arm for a moment. Repeat until the console
displays correct feedback. When the Reed Switch is
correctly adjusted, reattach the left Pedal Guard (8)
and the left Side Shield Cover
(14).
Leveling
Feet
49
54
23
15
8
MAINTENANCE AND TROUBLESHOOTING
4
14