Filter
Top Products
7
4.
With the help of a second person, carefully
raise
the Upright (83) to a vertical position. Press the
Lock Knob Sleeve (87) into the right side of the
left Upright, and press the Lock Knob Spacer
(86) into the other side of the left Upright.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (If there
are two collars, make sure that there is one on
each side of the spring.) Next, insert the pin into
the Lock Knob Sleeve (87) and the left Upright
(83). Then, tighten the knob back onto the pin.
83
86
87
Knob
Spring
Collar
Pin
4
28
83
3
28
3.
With the help of a second person, carefully tip
both Uprights (83) to the floor.
Insert the three Cage Nuts (28) into the three in-
dicated holes in the treadmill.
To insert each Cage Nut (28), first hook one side
of the Cage Nut into a hole and then use a flat-
bladed screwdriver to press the other side into
the hole, as shown.
96
95
T
hick
S
ide
95
95
73
2
2. Insert two 4 1/2" Bolts (96) with Handrail
W
ashers (95) into the right Upright (83). Next, lift
the right Handrail (73) slightly and align the
Handrail Bolts with the holes in the Handrail.
Thread the Handrail Bolts into the Handrail.
Do
n
ot tighten the Handrail Bolts yet. Be careful
not to pinch the wires.
Attach the left Handrail (not shown) in the same
way. Make sure that the Handrail Washers (95)
are flush against the Uprights (83), with the thick
sides facing the center of the treadmill, as shown
in the inset drawing. Then,
tighten all four
Handrail Bolts (96).
83
83