NordicTrack NTL09107.0 Treadmill User Manual


 
18
HOW TO USE THE CUSTOM WORKOUT CENTER
1.
I
nsert the key into the console.
S
ee HOW TO TURN ON THE POWER on page
14.
2.
Select the Custom Workout Center.
To use a Custom Workout Center, press the Select
Profile increase button.
Select your profile, workout time, minimum speed,
and maximum speed by repeatedly pressing the in-
crease and decrease buttons next to each selec-
tion. After each selection, press the Start Workout
button. Note: Pressing the Start Workout button at
this time will not start the custom workout. If you do
not press the Start Workout button, the display will
advance to the next selection after a few seconds.
Each custom workout is divided into segments.
One speed setting and one incline setting are pro-
grammed for each segment.
3. Press the Start Workout button to start the
workout.
A moment after you press the Start Workout but-
ton, the walking belt will begin to move. Hold the
handrails and begin walking.
During the workout, the
profile will show your
progress. The flashing
segment of the profile
represents the current
segment of the workout.
The height of the flashing segment indicates the
speed setting for the current segment. At the end of
each segment, a series of tones will sound and the
n
ext segment of the profile will begin to flash. The
new speed and incline settings will appear in the
d
isplay for a few seconds.
The workout will continue in this way until the last
segment of the profile flashes in the display and the
last segment ends. The walking belt will then slow
to a stop.
If the speed or incline setting is too high or too low
at any time during the workout, you can manually
override the setting by pressing the speed or incline
buttons;
however, when the next segment of the
workout begins, the treadmill will automatically
adjust to the speed and incline settings for the
next segment.
To stop the workout at any time, press the Stop
button. To restart the workout, press the Start button
or the Speed increase button. The walking belt will
begin to move at 1 mph. When the next segment of
the workout begins, the treadmill will automatically
adjust to the speed and incline settings for the next
segment.
4. Monitor your progress with the displays.
See step 5 on page 15.
5. Measure your heart rate if desired.
See step 6 on page 16.
6. When you are finished exercising, remove the
key from the console.
See step 7 on page 16.
Current Segment