Filter
Top Products
1
1
If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
R
emove the indicated #8 x 3/4" Screw (12) and
the Access Door (87) from the Console Back
(91).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Back
(91).
Hold the receiver so the small cylinder
is oriented as shown and is facing the
Console Back.
Attach the receiver to the plastic
posts on the Access Door (87) with the two in-
cluded small screws.
3.
Be careful not to pinch the wires. Reattach
the Access Door (87) with the #8 x 3/4" Screw
(12). Discard the other wires included with the
receiver.
A
87
Small
C
ylinder
12
91
Wire
Small
S
crews