Filter
Top Products
9
8. Insert the indicated connectors into the Right
U
pright (78).
Next, insert the fronts of the brackets on the
Bridge (95) into the Uprights (74, 78), and then
f
ully insert the brackets. Make sure that the plas-
tic edges of the Bridge (95) are inside the
Uprights.
Attach the Bridge (95) with six 1/4" x 1/2" Bolts
(7) and six 1/4" Star Washers (10);
start all six
Bolts and then tighten them.
See steps 4 and 6.
Tighten the four 3/8" x 4 1/2"
Bolts (6).
10
7
95
Connectors
Front
Edge
74
78
10
7
7
7
8
9. With the help of a second person, hold the con-
sole assembly near the Bridge (95). Connect the
Bridge Wire (52) to the console assembly wire.
Make sure to connect the connectors prop-
erly (see the inset drawing in step 7). The
connectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Connect the Console Ground Wire (101) to the
console assembly ground wire. Insert the wires
into the console assembly.
Attach the console assembly with three 3/8" x
1 1/4" Bolts (5) and three 3/8" Star Washers (9).
Be careful not to pinch the wires.
Console
Assembly
52
101
95
5
9
9
10. Identify the Storage Latch (53). Remove the tie
from the end of the tube. Make sure that the
sleeve has been slid over hole 1 and that the
Latch Knob (54) is locked into hole 1.
Pull on
the sleeve to make sure that it is locked into
place.
10
54
Sleeve
Hole 1
Tube
53