Filter
Top Products
4. SYMPTOM: THE HEART RATE MONITOR DOES NOT FUNCTION PROPERLY
a. See How to Use the CardioTrack TM Heart Rate Monitoron pages 8 and 9, and Pulse Disp/ayon page 13.
5. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the key
and UNPLUG THE POWER CORD. Using the included allen
wrench, turn the left rear roller adjustment bolt clockwise, and
the right bolt counterclockwise, 1/4 of a turn each. Be careful not
to overtighten the walking belt. Plug in the power cord, insert the
key and run the treadmill for a few minutes. Repeat until the
walking belt is centered.
b. If the walking belt has shifted to the right, first remove the
key and UNPLUG THE POWER CORD. Using the allen wrench,
turn the left rear roller adjustment bolt counterclockwise, and the
right bolt clockwise, 1/4 of a turn each. Be careful not to over-
tighten the walking belt. Plug in the power cord, insert the key
and run the treadmill for a few minutes. Repeat until the walking
belt is centered.
c. If the walking belt slips when walked on, first remove the key
and UNPLUG THE POWER CORD• Using the allen wrench, turn
both rear reeleradjustment bolts clockwise, 1/4 of a turn. When
the walking belt iscorrectly tightened, you should be able to lift
the edges of the walking belt 3 to 4 inches offthe walking plat-
form. Be careful to keep the;walking belt centered• Plug in the
power cord, insert the key a_qdrun the treadmill for a few min-
utes. Repeat until the waikir_'.gbelt is proper_y tightened.
6. SYMPTOM: THE WALKING ,BELT SLOWS WHEN WALKED ON
a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.
b. Ifthe walking beTtis overtigh!ened, treadmill performance may
decrease and the walking.be'_ pay- be permanent y damaged.
Remove the key and UNPLUG THE POWER CORD. Using the
allen wrench, turn both rear_,_0!leradjustment bolts counterclock-
wise, 1/4 of a turn. When the walking belt is correctly tightened,
you should be able to lift the edges of the walking belt 3 to 4
inches off the walking platform. Be careful to keep the walking
belt centered. Plug in the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is prop-
erly tightened.
Rear Roller Adjustment Bolts
c. if the walking belt still slows when walked on, please contact our Customer Service Department.
7. SYMPTOM: THE SPEED OF THE WALKING BELT FLUCTUATES OR DOES NOT REACH 12 MPH.
a. Make sure that no other appliance is on the same circuit as the treadmill
25