Filter
Top Products
9
Arm Assembly
46
12
45
33
20
9
9
20
33
10. Attach the Press Arm (46) to the Press Frame (12)
with two 3/8” x 3” Bolts (45) and two 3/8” Nylon
Locknuts (50).
Insert a 2” Square Inner Cap (33) into each end of
the Press Arm (46).
Turn one of the Adjustment Knobs (9) on the Press
Arm (46) counterclockwise to loosen it. Pull out the
Knob as far as possible and slide a Handle (20) into
the Press Arm. Release the Knob and let it snap into
one of the adjustment holes in the Handle. Tighten
the Knob fully. Repeat for the other Handle.
10
50
11. Attach the Handles (105) to the Sliding Seat Frame
(74) with four 1/4” x 1 1/2” Bolts (101) and four 1/4”
Nylon Locknuts (25).
Press a 2” Square Inner Cap (33) into the indicated
end of the Sliding Seat Frame (74).
101
101
105
25
33
74
11
25
105
9
9. Open the parts bags labeled “ARM ASSEMBLY”.
Attach the Leg Lever Lock (11) to the front leg of the
Base (8) with a 5/16” x 3” Bolt (78), three 5/16” Flat
Washers (80), and a 5/16” Nylon Locknut (81). Do not
overtighten the Nylon Locknut; the Leg Lever
Lock must pivot easily.
78
11
80
80
81
Front
Leg
8