Filter
Top Products
17. Wrap the Leg Press Cable (76) under a 4” Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
Leg Press Base (84) with a 3/8” x 3 3/4” Bolt (92), a
3/8” Flat Washer (55), and a 3/8” Nylon Locknut (50).
Be sure that the Leg Press Cable (76) is routed in
the direction shown, and that the Cable Trap (44)
is positioned to hold the Cable in the pulley
groove.
18. Wrap the Leg Press Cable (76) around a 4” Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
3/8” x 5” Carriage Bolt (82) in the Stabilizer (5) with a
3/8” Nylon Locknut (50).
Be sure that the Leg Press Cable (76) is routed in
the direction shown, and that the Cable Trap (44)
is positioned to hold the Cable in the pulley
groove.
16. Wrap the Leg Press Cable (76) up around a 4” Pulley
(35). Attach the Pulley and a Cable Trap (44) to the
Rear Press Upright (97) with a 3/8” x 3 3/4” Bolt (92),
a 3/8” Flat Washer (55), and a 3/8” Nylon Locknut
(50).
Be sure that the Leg Press Cable (76) is routed in
the direction shown, and that the Cable Trap (44)
is positioned to hold the Cable in the pulley
groove.
16
55
44
97
35
76
50
17
44
84
76
55
92
50
18
76
50
35
82
5
44
15. Open the parts bags labeled “CABLE ASSEMBLY”
and “4 PULLEYS.” Refer to the Cable Diagram on
page 21 as you assemble the cables.
Identify the Leg Press Cable (76) by referring to
page 21. Attach the Leg Press Cable to the indicated
hole in the Leg Press Base (84) with a 3/8” x 3” Bolt
(45), two 3/8” Flat Washers (55), a 5/8” x 1/4”
Bushing (90), and a 3/8” Nylon Jamnut (63).
15
55
55
76
90
84
63
45
Cable Assembly
11
92
35