Filter
Top Products
36. Feed the end of the Low Cable (72) through the indi-
cated slot in the Main Upright (3).
Wrap the Low Cable (72) around a 4” Pulley (35).
Attach the Pulley inside the slot in the Main Upright
(3) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat
Washers (55), two 5/8” x 1/2” Pulley Bushings (42),
and a 3/8” Nylon Jamnut (63).
36
Slot
63
42
55
35
42
72
3
55
54
17
37. IMPORTANT: Follow the Cables (73, 72 [not
shown], 76 [not shown]) from end to end; make
sure that they are in the grooves of the pulleys,
and that the Cables and pulleys move smoothly.
Thread the 1/2” Plain Nut (68) part way onto the bolt
at the end of the High Cable (73).
Place the 1 1/2” Flat Washer (40) on top of the Weight
Tube (36). Tighten the bolt at the end of the High
Cable (73) into the threaded hole in the Weight Tube
until the Cables (73, 72 [not shown], 76 [not shown])
are tight.
Tighten the 1/2” Plain Nut (68) against the 1 1/2” Flat
Washer (40).
37
Bolt
36
26
40
68
73