Filter
Top Products
M/° - units of angular measurement: mils or degrees
Shape of the reticle: cross shape or rectangular shape (2).
rEC1 - recall function. Upon pressing the Action button (6) (fig.
1) the Display will sequentially show results of last 10
measurements, starting from the latest one. The number
appearing after word "rEC" shows the number of the
measurement counted back in the sequence. When the System is
in inactive state the 10 previous measurements are stored within
the System and may be recalled at any time.
cLr - clear data function: upon pressing the Action button (6)
(fig. 1) the entire data on all previous measurements will be
erased. This function doesn’t change the chosen modes. You can
erase the assigned mode only by assigning a new one.
Note: After changing a battery the recall stack should be
cleared by exercising the cLr mode.
OVER 100 – indicates that gating mode is on.
Distance measuring procedure includes instant statistical
processing of the package of single measuring sessions for each
laser pulse. Qualitative result of the statistical processing is
presented on the Display as a message TARGET
REFLECTION (5).
17
5.4. Gating distance selection
You can exclude all targets, which are closer than the preset
distance. This is useful when you aim your target through bushes
or wires, or you are not interested in targets closer than a certain
distance. The step of gating is 100 meters starting from 100
meters and up to 7000 meters (such a large maximum gating
distance is reserved for future extensions). This means that you
potentially can set the gating distance larger than the maximum
measuring range. The device will not be able to measure
anything in this regime. To remove gating mode you should
choose Standard1 or Standard2 modes.
Note: The gating distance can be increased only. If you want to
decrease it, you should remove gating mode and then choose it
again.
Note: You can exit gating selection cycle without gating
distance setting by clicking the M button 70 times (all possible
gating distances passed, nothing was chosen) or by holding the
M button during 2 seconds (“escape” function, see above).
5.5. Additional display information
The System operates in the setting Modes that are displayed as
follows (refer to Fig.3):
Y/M – units of measurement: yards or meters (3).
KMH/MPH – units of speed measurement: km/hour or
miles/hour (3).
16