Filter
Top Products
override reticle type and target selection with the sub selection
code. For example, Standard 1 mode implies cross reticle. If you
choose rectangular reticle (sub selection code 10), you change
the reticle shape and leave all other parameters of this mode
intact. If then you choose Standard1 again, the reticle will turn
back crosshair. The last set mode overwrites all features that it
controls.
The third standard mode is assigned to Code 8. It determines
measurement units and features as Yards, Degrees, Degrees,
Crosshair reticle, Auto target selection.
All other modes determine only one parameter to measure. For
example, Code 14 allows to measure speed of the objects as
kilometers per hour. The shape of reticle and target selection will
remain the same, as they had been set before you selected the
Code 14. Now you can choose a new reticle shape, still
remaining in the speed measuring mode. This example
demonstrates that Codes 9-13 replace one selected feature
independently, and all other codes can replace more than one
feature in a bunch.
If you want to leave the mode switching procedure without
remembering your choice, you should press and keep held the M
button for more than two seconds. This works like “Escape” key
on a computer keyboard. The rangefinder will remain in the last
set mode and return to the READY state.
Full trek of all possible modes available is depicted on Figure 4.
15