Filter
Top Products
13
1. Mount LAM on the weapon.
2. Fix the weapon in the aiming rest.
3. Insert the laser bore sight into the barrel.
4. Zero the bore sight in accordance with its operation
manual.
5. Set the target at the distance, required for this weapon
and this target.
6. Activate LAM in ILP mode.
7. Set minimal divergence of the illuminator channel.
8. Set laser boresight on the aiming mark on the target.
9. Superpose centers of the spots produced by the aimer
and illuminator on the aiming mark by rotating
adjustment knobs (1, Fig. 1), (2, Fig. 1), (17, Fig. 2).
10. Check again that all three spots (laser bore sight
mark, aimer mark and center of the illuminator mark)
are on the correct aiming point on the target.
11. Turn LAM off.
Adjusting with iron weapon sight
1. Mount LAM on the weapon.
2. Fix the weapon in the aiming rest and aim it by
means of an iron sight at the aiming mark on the
target.
3. Activate LAM in ILP mode.