LifeSpan TR1550-SL Treadmill User Manual


 
Handlebar Support Post Assembly
Note: During the handlebar assembly process it is best to wait to tighten all screws until after the
handlebars are assembled.
1. (a.) Locate the right side handlebar support post, remove the three Button-Head screws at
the bottom of the post, and connect the wiring harness on the bottom of the support post
with the wiring harness coming from the base (see illustration). Make sure that the connectors
are properly aligned before pushing them together. Once pushed together, slide the connectors
inside the bottom tube.
(b.) Push the handlebar support post into the base frame. Be careful not to pinch the wiring
when you slide the top support post into the base tube.
Make sure that you align the 3 holes on the bottom of the tube with the 3 holes in the base
tube (see illustration b).
2. Take the left side support post and slide it into the tube on the left side of the base.
Make sure that you align the 3 holes on the bottom of the tube with the 3 holes in the base
tube (see illustration b).
Note: The left support post does "not" have wire connectors coming out of the bottom.
8
ba
Align the
holes on the
outside of
the frame