Filter
Top Products
©
2006 Life Fitness, a division of Brunswick Corporation. All rights reserved.
Life Fitness is a registered trademark of Brunswick Corporation.
TCLC 6.07.06 8060901 RevA-2
Seated Leg Curl
Assembly Instructions
NOTE: Some components have been removed from the illustration for
clarity.
17. Insert one end of the CABLE (44) into the cam of the WORKARM (29).
Thread the cable approximately 1/2 inch into the cam.
Route the CABLE beneath the CAM GUARD (24) and around the OUTPUT
CAM ASSEMBLY (A). Insert the remaining end of the CABLE through the
inner hole of the OUTPUT CAM ASSEMBLY.
Insert the CABLE RETAINING PLATE (45) over the end of the CABLE.
Install two HEX JAM NUTS (46) to the end of the CABLE.
Tighten the HEX JAM NUTS until the WORKARM begins to move and all
PUSH PINS (B) still move in and out freely. Be sure the HEX JAM NUTS
are tight against each other.
18. Attach the OUTPUT CAM COVER PLATE (47) to the OUTPUT CAM
ASSEMBLY (A) using three M10 X 45mm BOLTS (18) and three 3/8" SAE
WASHERS (5).
19. Place the unit in the intended place for use and check stability. If the unit
is not stable, the FEET (C) can be adjusted by inserting or removing sup-
plied SHIMS (51).
To add or remove SHIMS, loosen the LEVELING FOOT BOLT (D) and
NUT (6) until the desired SHIM(S) can be inserted or removed. Lightly
tighten the BOLT and NUT. Do not over-tighten the BOLTS.
20. Install HOLE PLUGS in all open bolt holes.