Filter
Top Products
6. Assemble the OUTPUT CAM (15), OUTPUT PLATE (16), and OUTPUT
RING (17) using three M10 X 45mm BOLTS (18) and three 3/8" SAE
WASHERS (5) as shown. Tighten the BOLTS securely.
7. Assemble the REAR SHROUD (19) and FRONT SHROUD (20) to the
TOWER (3) using four M10 X 20mm BOLTS (21), four 3/8" SAE WASH-
ERS (5) as shown. Be sure all tabs along the sides and top of the
SHROUDS are fully engaged in the slots located inside the TOWER.
Tighten the BOLTS securely. Do not over-tighten the BOLTS.
8. Secure the OUTPUT CAM ASSEMBLY (A) to
the TOWER AXLE (B) using one M10 X 25mm
BOLTS (22), one 3/8" SAE WASHERS (5) and
one PLATE (23) as shown. Tighten the BOLT
securely.
IMPORTANT: Be sure the OUTPUT CAM
ASSEMBLY is oriented as shown before secur-
ing it to the TOWER HUB.
9. Attach the CAM GUARD (24) to the FRONT
SHROUD (20) using two M5 X 10mm PHILLIPS
SCREWS (25). Tighten the SCREWS securely.
Do not overtighten the SCREWS.