Filter
Top Products
Seated Leg Curl
Assembly Instructions
1. LOOSELY assemble the FRONT BRACE (1) and REAR BRACE (2) to the
TOWER (3) using four M10 X 130mm BOLTS (4), eight 3/8" SAE WASH-
ERS (5) and four M10 NYLOCK NUTS (6) as shown.
2. LOOSELY assemble the SEAT FRAME (7) to the FRONT BRACE (1) and
REAR BRACE (2) using four M10 X 90mm BOLTS (8), eight 3/8" SAE
WASHERS (5) and four M10 NYLOCK NUTS (6) as shown.
3. LOOSELY assemble the TOP BRACE (9) to the SEAT FRAME (7) and
TOWER (3) using two M10 X 35mm BOLTS (10), four 3/8" SAE WASH-
ERS (5) and two M10 NYLOCK NUTS (6) at the SEAT FRAME and two
M10 X 70mm BOLTS (11), four 3/8" SAE WASHERS (5) and two M10
NYLOCK NUTS (6) at the TOWER as shown.
4. Tighten all BOLTS and NUTS securely.
5 Assemble the MAIN PIVOT BRACKET (12) to the TOWER (3) using one
TOWER SUPPORT PLATE (13) (as shown), two M10 X 75mm BOLTS (14),
four 3/8" SAE WASHERS (5) and two M10 NYLOCK NUTS (6) at the top
of the MAIN PIVOT BRACKET. Use one M10 X 70mm BOLT (11), two 3/8"
SAE WASHERS (5) and one M10 NYLOCK NUTS (6) at the bottom of the
MAIN PIVOT BRACKET. Tighten the BOLTS and NUTS securely.