Filter
Top Products
10. Attach the KNEE SUPPORT (26) to the MAIN PIVOT BRACKET (12) and
SEAT FRAME (7) using seven M10 X 30mm BOLTS (27), fourteen 3/8"
SAE WASHERS (5) and seven M10 NYLOCK NUTS (6) as shown. Tighten
the BOLT and NUTS securely.
Insert the KNEE SUPPORT ENDCAP (49).
11. Insert the LONG SPACER (28) and two BEARINGS (29) into the MAIN
PIVOT BRACKET (12) as shown. Carefully insert the WORKARM (30) into
the MAIN PIVOT BRACKET and secure it with one M10 X 25mm BOLT
(22), one 3/8" SAE WASHER (5) and one PLATE (23). Tighten the BOLT
securely.
Insert the BEARING HOUSING CAP (31) as shown.
12. Attach the COUNTER WEIGHT (32) to the WORKARM (30) using two M10
X 90mm BOLTS (8) and two 3/8" SAE WASHERS (5). Tighten the BOLTS
securely.
Seated Leg Curl
Assembly Instructions