Life Fitness LCD Entertainment Ready Home Gym User Manual


 
15
MODELS 95LI SUMMIT TRAINER
TOOLS REQUIRED: Metric Hex Key Set, Side Cutters, T-45 Torx Wrench
1. Remove the CONSOLE SUPPORT TOP CAP (a).
2. Remove the two SCREWS (b) securing the CONSOLE SUPPORT COVER (c). Remove
the CONSOLE SUPPORT COVER and set it and the SCREWS aside.
3. Remove the four SCREWS (d) securing the DISPLAY CONSOLE (e). Set
the SCREWS aside. Tilt the CONSOLE forward and disconnect all
cables. Set the CONSOLE aside.
4. Locate the REMOTE CONTROL (f). Configure the MOUNTING
BRACKET (g) for a vertical installation. Secure the REMOTE CON-
TROL to the top of the HANDRAIL (h) and just left of the RIGHT
BULLHORN (j) as shown. Tighten the BRACKET MOUNTING
SCREWS securely.
5. Route the REMOTE CABLE (k) below the HANDRAIL (h) , around the
MONOCOLUMN (m) and up through the CONSOLE SUPPORT (n) along-
side the POWER CORD and COAXIAL CABLE.
6. Locate the TV MOUNTING BRACKET (o). With the mounting holes in
the tube facing downward, slide the tube portion of the MOUNTING
BRACKET into the top of the CONSOLE SUPPORT (n). Align the
inserts in the tube with the mouting holes on the underside of the
CONSOLE SUPPORT. Secure the MOUNTING BRACKET using two
SCREWS (p). Tighten the SCREWS securely.
CAUTION: Do not pinch and cables when inserting the MOUNTING BRACKET
into the CONSOLE SUPPORT.
7. Re-install the DISPLAY CONSOLE (e) using the four previously removed SCREWS (d). Tighten the SCREWS to 6-8
in-lbs. Do not overtighten the SCREWS.
CAUTION: Do not pinch any wires when assembling the DISPLAY CONSOLE to the CONSOLE SUPPORT.
8. Attach the ADAPTER BRACKET (q) to the ENTERTAINMENT CONSOLE (r) using four SCREWS (s). Tighten the
SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS.
Attach the ENTERTAINMENT CONSOLE to the UPPER MOUNTING PLATE (t) using four SCREWS (u) and
WASHERS (v). Tighten the SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS.
9. Connect the COAXIAL CABLE, POWER CORD and REMOTE CABLE (k) to the rear of the ENTERTAINMENT
CONSOLE (r) as shown under Console Cable Connections at the end of this manual.
10. CABLE TIE (w) any excess cable together behind the ENTERTAINMENT CONSOLE (r) and position the cables
between the MOUNTING BRACKET (o) and the DISPLAY CONSOLE (e).
11. Re-install the CONSOLE SUPPORT COVER (c) and secure it using the two previously removed SCREWS (b).
12. Locate the NEW TOP CAP (x). Place the NEW TOP CAP into position at the top
of the CONSOLE SUPPORT COVER (c). Be sure the TOP CAP snaps securely
in place.
13. Secure the POWER ADAPTER (y) to the FRONT STABILIZER (z) using
two CABLE TIES (w) as shown. Be sure the CABLE TIES are pulled
tight and trim the excess CABLE TIES. Connect the screw-type con-
nector of the POWER CORD (aa) to the frontside receptacle. Bundle
excess POWER CORD and store under the unit. Connect the COAXIAL
CABLE (bb) to the broadcast supply cable in similar fashion.
14. Connect the POWER SUPPLY CORD to the POWER ADAPTER (y).