Life Fitness LCD Entertainment Ready Home Gym User Manual


 
19. With the remaining TV BRACKET (15) oriented as shown, install it to the back of
the TV (16) using four SCREWS (17) and WASHERS (6). Tighten the SCREWS
securely. (8-10 ft. lbs.)
NOTE: Be sure the side holes of the TV BRACKET are oriented as shown.
20. Position the TV BRACKETS (8 & 15) together as shown below and secure
them together using one BOLT (18), WASHER (19) and NUT (20). Leave
the BOLT and NUT loose at this time.
NOTE: Be sure the PIVOT POST of the TV BRACKET (15)
engages onto TV BRACKET (8).
21. Remove the tape from the end of the MEDIA CABLES
(POWER, COAXIAL, I-R CONTROL (remote cable on achieve con-
soles), S-VIDEO)
. Connect all cables to their corresponding
jacks located on the back of the TV (16) (See end of instruc-
tion manual for TV connection details). Feed any excess
MEDIA CABLE into the MAIN BRACKET (4).
22. Install the top MAIN BRACKET CAP (21) to the top of the MAIN BRACKET ASSEMBLY (4).
23. Replace the REAR CONSOLE COVER (10) and secure it using the previously removed two SCREWS (9). Tighten
the SCREWS securely. (8-10 ft. lbs.). Do not over-tighten the SCREWS.
24. Slide the BRACKET COVER (7) down to meet the REAR CONSOLE COVER (10). Snap the BRACKET COVER
into the REAR CONSOLE COVER.
25. Align the LOWEST SIDE HOLES on the TV BRACKETS (8 & 15). Secure the TV BRACKET into proper position
using one SCREW (22) on each side.
NOTE: Life Fitness recommends aligning and securing the TV at the lowest side holes (D) as shown.
26. Plug in the treadmill and power on the treadmill and TV. Refer to the Owners Manual for proper TV setup.
INSTALLATION
8