Filter
Top Products
10. My treadmill will not turn on.
a. Make sure the treadmill’s power cord is connected to the treadmill at one end and is plugged into a power
outlet at the other. Also, make sure the power switch is pushed to ON. The power switch is
located on the front of the treadmill right below the motor cover.
11. The handrails on my treadmill wobble.
a. Make sure to tighten all the bolts that are on the uprights and handlebars.
12. My treadmill shakes a lot when I run on it.
a. Turn off the treadmill and make sure all assembly hardware is tightened. If shaking still occurs, adjust the
levelers under the frame until the shaking ceases.
13. The following messages appear on the display console: PUT BACK MAG or REPLACE SWITCH.
a. These messages are displayed if the E-Stop Key is not in place on the activity zone. Make sure that the E-
Stop Key is properly placed on the activity zone.
b. These messages may display the first time the treadmill is turned on after initial customer assembly of the
treadmill, if a cable was not properly connected. Check that all three cables are properly connected to the
console.
25