Filter
Top Products
21
D. Start: Causes the belt to begin moving at 0.5 mph
and 0% elevation.
E. Stop: Causes the belt to slow to a gradual stop.
One push pauses the workout, two pushes display
workout information, and three pushes reset the
workout.
F. Incline Arrows: Change the belt’s incline gradual-
ly, increasing (UP ARROW) or decreasing (DOWN
ARROW) the incline by 0.5% each time the user
presses an arrow.
G. Speed Arrows: Change the belt’s speed gradually, increasing (UP ARROW) or decreasing (DOWN ARROW) the
speed by 0.1 mph each time the user presses an arrow.
H. Low/Med/High: Changes the belt’s incline immediately to a preset value. Initially these buttons are set to change
the incline to 1.5% (Low), 3% (Mid) and 5% (High). However, the user can set these buttons to new values by first
changing the belt’s incline to the desired new value, then holding down the button the new value will be assigned to
until the treadmill beeps. Note that the smallest value must always be assigned to the Low key and the highest value
to the High key.
I. Walk/Jog/Run: Changes the belt’s speed immediately to a preset value. Initially these buttons are set to change the
speed to 3 mph (Walk), 5 mph (Jog) and 7 mph (Run). However, the user can set these buttons to new values by
first changing the belt’s speed to the desired new value, then holding down the button the new value will be
assigned to until the treadmill beeps. The smallest value must always be assigned to the Walk key and the highest
value to the Run key.
J. E-Stop Magnet: This circular magnet connects to the E-Stop Lanyard, which must be clipped to the user’s clothing
when the treadmill is in use. Pulling the lanyard so that it comes free of the magnet will stop the treadmill’s striding
belt. This serves as a safety feature, stopping the belt should the user stumble or fall. Replace the magnet to reset
the system.