Filter
Top Products
1.2 S
ETUP
Read the Operation Manual before setting up the Life Fitness Summit Trainer.
WHERE TO PLACE THE LIFE FITNESS
®
SUMMIT TRAINER
Following all safety instructions in Section 1.1, move the Life Fitness Summit Trainer to the loca-
tion in which it will be used. See Section 7, titled Specifications, for the dimensions of the foot-
print. Allow one foot of clearance in front of the Life Fitness Summit Trainer to allow for move-
ment of the total-body arms.
HOW TO
STABILIZE THE LIFE FITNESS SUMMIT TRAINER
After placing the Life Fitness Summit-Trainer in position,
check the unit for stability by attempting to rock the unit.
Any slight rocking rocking indicates that the unit must be
leveled. There are a total of (5) feet on the Summit Trainer
for stability. The (2) rear feet under the rear step should
require no adjustment. The (1) middle leveler should be
adjusted last and is only for support, not leveling. Check
the (2) front levelers to determine which foot does not rest
fully on the floor. Rotate the foot counter-clockwise to
lower it. Recheck the stability and adjust again as needed
until the unit is stable and no longer rocks. Lower the mid-
dle leveler until it contacts the floor. Lock the adjustment
nut on both the (2) front and middle levelers by tightening
the jam nut with a 17 mm wrench.
CHECK FOR POWER
The console is powered by a rechargeable 6-volt battery. Check the battery by pressing the START key.
The console should light up, and the MESSAGE CENTER should display a prompt to set up a workout. If
this does not occur, mount the Life Fitness Summit Trainer and begin pedaling. The console should then
light up, making it possible to program a workout. Pedal for 10 to 20 minutes at 0.5 mph (0.8 km/h) or
faster during a workout to charge the battery. Afterwards, the pedal action during workouts keeps the bat-
tery charged. If the console still does not light, contact Life Fitness Customer Service. See section 6.5,
titled How to Obtain Product Service, for more information.
FITNESS AND ENTERTAINMENT NETWORKING
Two interchangeable network ports allow the Life Fitness Summit Trainer to be connected to a fitness
entertainment system and/or a network, such as FitLinxx
TM
interactive fitness network.
• Fitness network: The network connection enables the console to upload user workout sta-
tistics to a fitness network database or to download remotely stored information, such a pre-
set workout program. See Section 4.2, titled Using the Workouts, for information on logging
onto a network.
• Entertainment: The network connection enables the console to power a third-party receiver
for use with a service such as the Cardio Theater
®
entertainment system or the
BroadcastVision
TM
entertainment system.
These ports are located on the back of the console and are enclosed by a removable cover. Any use of
the ports for other than their intended purpose could void the product warranty.
7