Filter
Top Products
FIGURE 11
9
• Insert the two GUIDE RODS (5) into the base
of the TOWER (1) as shown in FIGURE 11.
Lubricate the GUIDE RODS with a slicon or
teflon spray that is available at most hardware
stores.
• Slide two WEIGHT STACK CUSHIONS (26)
down over the GUIDE RODS (5). See FIGURE
11.
• Using EXTREME CARE slide twenty
WEIGHT PLATES (54) down over the GUIDE
RODS (5) with the “PARABODY” side up and
the key-hole facing as shown in FIGURE 11.
• SECURELY assemble the WEIGHT STACK
SHAFT (19) to the HEAD PLATE (20) using
one 3/8 X 1” BUTTON HEAD CAP SCREW
(39) and one 3/8” LOCK WASHER (42). (Note:
The bolt hole in the HEAD PLATE (39)
should be on top.)
• Carefully Slide the HEAD PLATE ASSEMBLY
down over the GUIDE RODS (5) onto the
weight stack as shown in FIGURE 11.
STEP 11:
STEP 10:
FIGURE 10
• Snap two WEIGHT PLATE BUSHINGS (25) into the
“PARABODY” side of all twenty WEIGHT PLATES
(54) as shown in FIGURE 10.
25
54
5
39 3/8 X 1”
BTN HD
20
42
19
54
26
1
53
52
• Apply one set of WEIGHT STACK LABELS -
LBS. OR KGS. (52) (53) to each WEIGHT
PLATE (54) as shown in FIGURE 11.