Filter
Top Products
Assembly
18
Step 9
Attach the Seat Pad (26) to the Seat Pad Support (13) using two Washers (102) and two Allen Bolts (96).
Slide the Seat Support assembly into the Seat Pad Support Receptacle (2) and secure by tightening the
Locking Pop Pin (52).
Install the Telescope (14) to the Back Pad Support (16) and secure in place using one Nylon Locknut (104),
two Washers (101), and one Bolt (99).
Install the Tilting (15) to the Back Pad Support (16) and secure in place using one Nylon Locknut (104), two
Washers (102), and one Bolt (88).
Attach the Back Pad (25) to Back Pad Support (16) using two Washers (102) and two Bolts (89).
Last, slide the Back Pad Support assembly into the receptacle on the Main Upright (3) and secure by tighten-
ing the Locking Pop Pin (52).
Figure 9