Filter
Top Products
Congratulations!
You have completed the assembly of your new Ironman INSPIRE Treadmill!
Assembly
9
10. Install the Left and Right Fenders to Base
using Philip Screw ST4.2X16 as shown in
Figure 8.
Figure 8: Left and Right Fender Installation
LEFT FENDER
BASE
PHILIP SCREW
ST4.2x16
RIGHT FENDER
11. Assembly is complete. Move Treadmill to
permanent location. See Moving Instructions.
Before operating the treadmill, adjust Levelers so
that Base of treadmill does not wobble. See
Figure 9.
Figure 9: Adjust Levelers
9. If Safety Latch Assembly will not secure cor-
rectly, turn the four Screws counter-clockwise a
half turn.
NOTE: DO NOT REMOVE SCREWS FROM
LATCH HOUSING.
Next, slide the Safety Latch Housing up or down
to align the Safety Latch with center of hole locat-
ed on the left handlebar. Tighten the four Screws
to secure the assembly in place.
SCREWS
LATCH HOUSING
Figure 7: Safety Latch Adjustment