Filter
Top Products
Assembly
8
FIGURE 7:
Step 1:
Connect Sensor and Tension Cables to
Console as shown is Figure 7.
Step 2:
Attach Console (33) to Upright using
four Screws. Note: The four Screws
will already be installed into the back of
Console(33) when you remove it from the
box.
CONGRATULATIONS!!!!!!
You have completed Assembly of your New Ironman 120r Recumbent.
FIGURE 6a, 6b,6c: Connect the Tension Knob to the Resistance Cable. Fit the Resistance Control Cable
into the slot of the Tension Knob. Pull the brass end of the Resistance Control Cable over the lip of the
Tension Knob Bracket. The connection should look like Figure 6c when completed.
6a
6b
6c
Figure 7