Filter
Top Products
Part No 1143214 5 ICCG Bed Rails
3. Carefully push the bolt through the mounting hole in the bed frame (Detail “B”).
4. Loosely install the hex nut on the bolt to secure the latch arm to the bed frame (Detail
“B”).
5. Loosen and remove the hex nut from the bar closest to the latch arm (Detail “A”).
6. Carefully push the bolt through the corresponding mounting hole in the bed frame
(Detail “A”).
7. Loosely install the hex nut on the bolt to secure the bar to the bed frame (Detail “A”).
8. Repeat STEPS 5-7 for the remaining bars.
9. Securely tighten all bolts and hex nuts securing the bars and the foot end latch arm to
the bed frame. Torque to 100-150 inch-pounds.
FIGURE 4 Installing/Using Nylasar Bed Rails - Installing the IH5748A Bed Rails
Using the IH5748A Bed Rails
NOTE: For this procedure, refer to FIGURE 5.
1. Perform one of the following:
• Raising - Lift up on the bed rail until
the rail locks into place.
• Lowering - Press in on the release
lever and push down on the rail.
FIGURE 5 Using the IH5748A Bed Rails
Release Lever
Spacer
DETAIL “B” - LATCH ARM HARDWARE
Bar
Bolt
Hex Nut
Latch Arm
Spacer
Bed
Frame
Bars
Bed Frame
Refer to Detail “A”
Refer to Detail “B”
Rubber
Bushing
Bar
Bearing
Bolt
Bed
Frame
Washer
DETAIL “A” - BAR HARDWARE
Hex
Nut
Spacer
Spacer
Bearing
Foot End
of Bed
Foot End of Bed
Release Lever
Bed Rail