Filter
Top Products
ICCG Bed Rails 2 Part No 1143214
ƽ ENTRAPMENT WARNING (CONTINUED)
Refer to the owner’s manuals for beds for additional product and safety information.
Mattress MUST fit bed frame and bed rails snugly to reduce the risk of entrapment.
After any adjustments, repair or bed service and before use, make sure all attaching
hardware is tightened securely. Rails with dimensions different from the original
equipment supplied or specified by the bed manufacturer may not be interchange-
able and may result in entrapment or other injury.
Installing/Using the Epoxy Bed Rails
NOTE: For this procedure, refer to FIGURE 1.
Installing 6801A and 6808A Bed Rails
1. Position the pivot brackets on the bed frame as shown in Details “A” and “B” of
FIGURE 1.
2. Loosely attach the pivot brackets to the bed frame with the hex bolts and locknuts.
NOTE: DO NOT tighten the hex bolts and locknuts at this time.
3. Slide the mounting pins of the bed rails through the pivot tubes.
NOTE: Make sure the release lever on the bed rail is pointing towards the foot end of the bed.
FIGURE 1 Installing 6801A and 6808A Bed Rails
Release Lever
DETAIL “B” - FOOT END TOP VIEW
DETAIL “A” - HEAD END TOP VIEW
Bed Rail (on the outside
of bed frame)
Bed Frame
Bed Rail (on the outside of bed frame)
Crossmember
Inside of
Bed Frame
Socket Screw
Pivot
Tube
Mounting Pin
Socket Screw
Mounting Pin
Bed Rail (on
the outside of
bed frame)
Pivot Bracket
Hex Bolt and Locknut
Pivot Tube
Pivot
Bracket
Hex Bolt
and Locknut
Inside of
Bed Frame
See Detail B
See Detail A