Filter
Top Products
ICCG Bed Rails 4 Part No 1143214
6. Secure the bed rail to the mounting bracket with the two socket screws.
7. Head End Mounting Bracket Only - Position the crossmember between the two bed
rails as shown in Detail “A” of FIGURE 2 on page 3.
8. Repeat STEPS 3-7 to install the other bed rail on the opposite side.
9. When installing bed rails 6815A, 6816A or 6803A on a bed used with an 80-inch
mattress, the head board mounting brackets MUST be adjusted. Refer to Changing the
Head Board Mounting Position on page 6.
Using the Epoxy Bed Rails
NOTE: For this procedure, refer to FIGURE 3.
1. Perform one of the following:
• Raising - Pull up on the bed rails while rotating towards the head end of the bed
until the bed rail locks into place.
• Lowering - Pull up on the release lever and push down on the bed rail while
rotating towards the foot end of the bed until the bed rail lowers into place.
FIGURE 3 Using the Epoxy Bed Rails
Installing/Using Nylasar Bed Rails
NOTE: The hardware shown in FIGURE 4 on page 5 is already assembled to the bars and latch
arms before shipment. It is not necessary to remove the hardware from the bolt or to remove the bolt
from the bars or latch arms. Holding the bolt in place while removing the hex nuts will prevent the
hardware from becoming disassembled. In case of disassembly, refer to FIGURE 4 on page 5 for the
correct placement of the hardware.
Installing the IH5748A Bed Rails
NOTE: For this procedure, refer to FIGURE 4 on page 5.
NOTE: Invacare recommends two people perform the following installation procedure. One person
should hold the bed rail up against the bed and one person should attach the rail to the bed.
1. Position the bed rail on the bed frame with the release lever towards the foot end of
the bed.
2. Loosen and remove the hex nut from the latch arm at the foot end of the bed (Detail
“B”).
Towards Foot End
of Bed
Bed Rail
Release Lever