Filter
Top Products
7
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.
NOTE: It is strongly recommended this machine to be assembled by two or more people to
avoid possible injury.
STEP 1 (See Diagram 1)
A) Slide two Ø2 ½” Round Rubber Bumpers (#43) onto the Guide Rods (#7). Insert the two
Guide Rods into the holes on the Rear Stabilizer (#8). Secure each Guide Rod with one
M10 x 1” Allen Bolt (#72) and ∅ ¾” Washer (#77) from the bottom.
B) Attach the rear of Main Base Frame (#1) to the Rear Stabilizer. Secure them with two M10 x
2 ¾” Carriage Bolts (#62), one 4 3/8” x 2” Bracket (#20), two Ø ¾” Washers (#77), and two
M10 Aircraft Nuts (#81). Do not tighten the nuts and bolts yet.
C) Attach the Front Stabilizer (#19) to the Main Base Frame (#1). Secure them with one M10 x
3” Allen Bolt (#74), one 4” x 2” Bracket (#29), two Ø ¾” Washers (#77), and one M10
Aircraft Nut (#81) to the top hole. Secure the bottom hole with one M10 x 2 1/2” Allen Bolt
(#64) and ∅ 3/4” Washer (#77) from the back.
D) Attach the Foot Plates (#30) to the Front Stabilizer (#19). Secure them with two M10 x 2 ¾”
Carriage Bolts (#62), Ø ¾” Washers (#77), and M10 Aircraft Nuts (#81).
E) Place the Vertical Frame (#2) onto the Main Base Frame. Secure them with two M10 x 3 ½”
Carriage Bolts (#63), one Pulley Bracket (#18), two Ø ¾” Washers (#77), and two M10
Aircraft Nuts (#81). Securely tighten all nuts and bolts previously installed.