Filter
Top Products
16
STEP 7 (See Diagram 7 & Cable Loop Diagram)
A.) Attach the 144” Lower Cable (#59) to the opening on the bottom of the Leg Developer (#9).
B.) Attach a Pulley (#41) to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#64), two ∅
7/8” Pulley Bushings (#35), and one M10 Aircraft Nut (#81).
C.) Draw the Cable underneath the Pulley towards the back of the machine through the opening on
the bottom of the Main Base Frame (#1) to an open bracket.
D.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#65), two Ø ¾”
Washers (#77), and one M10 Aircraft Nut (#81).
E.) Draw the Cable underneath the Pulley towards the back of the machine to the Pulley Bracket
(#18) underneath the Main Base Frame.
F.) Attach a Pulley to the bracket. Secure it with one L-shaped Bracket (#23), one M10 x 2” Allen
Bolt (#66), two ∅ ¾” Washers (#77), and one M10 Aircraft Nut (#81).
G.) Pull the Cable upward to the Angled Double Floating Pulley Brackets (#15) previously
installed in Step 6. Repeat Step D to install another Pulley.
H.) Draw the Cable around the Pulley then pull downward to the open bracket on the Main Base
Frame. Repeat Step D to install another Pulley.
I.) Draw the Cable around the Pulley then pull upward to the Double Floating Pulley Bracket (#14)
previously installed in Step-5. Repeat Step D to install a Pulley.
J.) Draw the Cable around the Pulley then pull downward to the bracket on the rear of Main Base
Frame. Attach the Cable to a 6-Joint Chain (#25) using a C-clip (#28). Secure the other end of
the Chain to the bracket with a M10 x 1” Allen Bolt (#72), two ∅ ¾” Washers (#77) and one
M10 Aircraft Nut (#81).
K.) Use the length of the Chain to adjust the tension of the Cable Loop System. If the Cables are
too loose, shorten the Chain.
L.) Attach the 15-Joint Chain (#27) to the end of the Cable by using a C-clip. Attach the Arm Curl
Handle (#12) to the Chain by using another C-clip. Replace Arm Curl Handle with the Ankle
Strap (#82) for various Leg exercises. Adjust the length of Chain to obtain the desired exercise.
Remove the Arm Curl Handle and Ankle Strap when using the Leg Developer.