Filter
Top Products
STEP 4 (See Diagram 4)
A) Attach the Front Press Base (#3) to the Upper Frame (#6). Secure it with one Axle (#24), two
Spacers (#79), and two M10 Aircraft Nuts (#81). Do not over tighten the Nuts.
B) Insert the axle on the Right Butterfly (#4) through the hole on the Front Press Base from the
bottom. Slide a Lock Ring (#60) onto the axle. Align the holes and secure it with one M6 x 1
5/8” Hex Bolt (#61) and M6 Aircraft Nut (#73). Repeat the same step to install the Left Butterfly
(#5).
C) Attach the Swivel Pulley Bracket Frame (#16) to the back of the Vertical Frame (#2). Secure it
with one M10 x 3 ½” Allen Bolt (#70), two Ø ¾” Washers (#77), and one M10 Aircraft Nut (#81).
D) Attach a Swivel Pulley Bracket (#17) to each end of Swivel Pulley Bracket Frame. Secure each
Bracket with one M10 x 2 ½” Allen Bolt (#64), two Ø ¾” Washers (#77), and one M10 Aircraft
Nut (#81).
E) Attach the Backrest Board (#56) to the Vertical Frame (#2). Secure it with two M8 x 2 ½” Allen
Bolts (#68) and Ø 5/8” Washers (#78).
DIAGRAM 4
11