Filter
Top Products
STEP 2 (See Diagram 2)
A.) Slide two Ø 2 ½” x 1” Rubber Bumpers (#65) onto the Guide Rods (#18). Attach
the two Guide Rods onto the Weight Stack Frame (#17). Secure the bottom of
Guide Rods with two M10x 1” Allen Bolts (#82) and two Ø ¾” Washers (#91).
B.) Pull the top of the two Guide Rods off the Weight Stack Frame. Slide 14 Weigh
Plates (#59) onto the Guide Rods. Make sure the deep groove on the Weight
Plates are all facing the machine and downward.
C.) Insert the Selector Rod (#24) through the center hole on the Weight Plates. Slide
the Selector Stem (#37) onto the Guide Rods.
D.) Push the top of Guide Rods back. Secure them to the Weight Stack Frame with
two M8 x 1 5/8” Allen Bolts (#86), four two Ø 5/8” Washers (#92), and two M8
Aircraft Nuts (#95).
8