Filter
Top Products
STEP 9 (See Diagram 9)
A.) Attach the Front Press (#6) to the Front Press Base (#5). Secure it with one 8 ¾” Long
Axle (#57), two Ø ¾” Washers (#91), and two M10 Aircraft Nuts (#94). Do not over
tighten the Nuts. Make sure the Front Press is able to swivel smoothly.
B.) Use the T-shaped Lock Pin (#40) to lock the Front Press to the Front Press Base in
desired position.
C.) Connect the Lat Bat (#21) to Upper Cable with two Hooks (#69) and one Short Chain
(#67).
D.) Connect the Shiver Bar (#22) to Lower Cable with two Hooks and one Long Chain (#68).
DIAGRAM 9
21