Filter
Top Products
STEP 8 (See Diagram 8)
A.) Attach the Backrest Board (#34) to Front Vertical Frame (#2). Secure it with two M8 x 2
1/8” Allen Bolts (#85) and two Ø 5/8” Washers (#92).
B.) Attach the Seat Pad to Seat Support (#11). Secure it with two M8 x 2 1/8” Allen Bolts
(#85) and two Ø 5/8” Washers (#92).
C.) Insert two Foam Tubes (#19) halfway through the holes on Seat Support and Leg
Developer (#10). Push four Foam Rolls (#55) onto the Tubes from both ends. Plug four
Foam Roll End Caps (#44) into the Ends.
D.) Attach the Arm Curl Bracket (#25) to the Arm Curl Pad (#32). Secure it with two M8 x
5/8” Allen Bolts (#87) and two Ø 5/8” Washers (#92).
E.) Attach the Arm Curl Bracket to the open bracket on the Arm Curl Stand (#9). Insert the
M8 x 3 ½” Allen Bolt (#84) through the open track on the Arm Curl Stand and the holes
on the Arm Curl Bracket then secure the Bolt with two Ø 5/8” Washers (#92) and one M8
Aircraft Nut (#95). Do not over tighten the Nut and Bolt. The Bolt needs to be able to
slide on the track freely.
F.) Insert the Arm Curl Stand into the opening on the Leg Developer. Use the M18 Lock
Knob (#52) to lock the Arm Curl Stand in position.
G.) Pull up and flip the Arm Curl Pad along the track facing back to the Leg Press Frame
when doing Leg Press exercises.
H.) Remove the Arm Curl Stand when doing Leg Developer exercises.
19