Filter
Top Products
STEP 13 (See Diagram 13 & 15)
A.) Attach the Ball-end of the 102” Leg Curl Cable (#87) to the opening on the Leg Developer (#23).
Install a Pulley (#58) to the opening. Attach two Bushings (#56) to the holes on the Leg
Developer. Secure it with a M10 x 2 ½” Allen Bolt (#97) and M10 Aircraft Nut (#110).
B.) Pull the Cable through the openings to the bracket on the Left Base Frame (#2). Install a Pulley.
Secure it with a M10 x 1 ¾” Hex Head Bolt (#92), two ∅ ¾” Washers (#106), and one M10 Aircraft
Nut (#110).
C.) Continue drawing the cable through the opening on the bottom of the Left Vertical Beam (#4).
Install another Pulley.
D.) Draw the Cable upward to the Double Floating Pulley Bracket (#30) previously installed in STEP
12B. Install another Pulley.
E.) Pull the Cable downward to the Swivel Frame (#26). Install another Pulley.
F.) Slide a Ring Cap (#80), Rubber Ball (#79) and ∅7/8” Washer (#78) onto the end of the Cable.
Screw a Connector (#48) onto the Cable. See E View.
DIAGRAM 13
18