Filter
Top Products
STEP 11 (See Diagram 11 & 15)
A.) Attach one end of the 327 ½” Leg Press Cable (#83) to the bracket on the Leg Press Pivot Arm
(#18). (See C View) Secure it with one M10 x 1” Allen Bolt (#99), two ∅ ¾” Washers (#106), and
one M10 Aircraft Nut (#110). NOTE: Do not over tighten this bolt. Make sure the head of the
cable can swivel on the bolt.
B.) Draw the Cable to the Vertical Supports (#16). Install a Pulley (#58). Secure it with one M10 x 5”
Allen Bolt (#96), two ∅ ¾” Washers (#106), and one M10 Aircraft Nut (#110). Draw the Cable
over this Pulley back to the Leg Press Pivot Arm (#18). Install another Pulley using one M10 x 1 ¾”
Hex Head Bolt (#92), two ∅ ¾” Washers (#106), and one M10 Aircraft Nut (#110).
C.) Draw the Cable towards back of the machine to the bottom of the Right Vertical Beam (#3).
Install a Pulley (#58) using one M10 x 1 ¾” Hex Head Bolt (#92), two ∅ ¾” Washers (#106), and
one M10 Aircraft Nut (#110). (See D View)
D.) Draw the Cable over the Pulley back to the Bench Press Frame (#11). Install a Pulley with one
M10 x 8 ½” Axle (#95), two ∅ ¾” Washers (#106), and two M10 Aircraft Nuts (#110).
E.) Draw the Cable back to the Right Vertical Beam (#3). Install a Pulley. (See D View).
F.) Draw the Cable to the Bench Press Frame (#11) and install another Pulley.
G.) Draw the Cable back to the Right Vertical Beam (#3) through the hole to the back of the Beam.
Install another Pulley.
H.) Draw the Cable upward to the Single Floating Pulley Bracket (#27) previously installed in STEP
9E. Install another Pulley.
I.) Draw the Cable over the Pulley downward to the bracket on the Right Base Frame (#1). Install
another Pulley.
J.) Draw the Cable all the way up to the bottom of the Right Upper Frame (#6). Install another Pulley.
K.) Then draw the Cable downward to install a Pulley to a Double Floating Pulley Bracket (#30). Let
the Bracket hanging for now.
L.) Finally draw the Cable upward to the Single Floating Pulley Bracket (#27) previously installed in
STEP 10C. Secure the end of the Cable to the Bracket with one M10 x 1” Allen Bolt (#99), two ∅
¾” Washers (#106), and one M10 Aircraft Nut (#110).
15