Filter
Top Products
STEP 6 (See Diagram 6 & Cable Loop Diagram)
A.) Attach the Ball end of the 205” Lower Cable (#49) to a Pulley (#36).
B.) Attach the Pulley to the open bracket on the Cross Brace (#3). Secure it with one M10 x
1 ¾” Allen Bolt (#58), two Ø ¾” Washers (#64), and one M10 Aircraft Nut (#66).
C.) Draw the Cable underneath the Pulley then upward to the hanging Double Floating
Pulley Bracket (#24) installed in Step-5. Install another Pulley.
D.) Draw the Cable downward to the open bracket on the Rear Stabilizer (#21). Install
another Pulley.
E.) Pull the Cable around the Pulley and upward to the Pulley previously installed on the top
of the Lat Bar Support Bracket (#20).
F.) Draw the Cable around the Pulley then downward to the bracket on the Sliding Weight
Post (#13). Secure the end of Cable to the bracket with one M10 x 1 3/8” Allen Bolt
(#59), two Ø ¾” Washers (#64), and one M10 Aircraft Nut (#66).
G.) Attach the Long Chain (#29) to the end of the Cable using a C-clip (#32). Attach the
Shiver Bar (#23) to the Chain using another C-clip.
14