Filter
Top Products
STEP 4 (See Diagram 4)
A.) Attach the Lat Bar Frame Bracket (#20) to the top of the Rear Vertical Frame (#7).
Secure it with two M10 x 5/8” Allen Bolts (#61) and Ø ¾” Washers (#64).
B.) Attach the Left & Right Lat Bar Frames (#10 & 9) to the Lat Bar Frame Bracket (#20).
Secure them with two M10 x 5 1/4” Allen Bolts (#53), four Ø ¾” Washers (#64), and two
M10 Aircraft Nuts (#66).
C.) Secure each Lat Bar Frame to the Upper Frame (#8) with one M10 x 4 ½” Allen Bolt
(#54), two Ø ¾” Washers (#64) and one M10 Aircraft Nut (#66).
D.) Securely tighten all Nuts and Bolts previously installed.
E.) Attach a Pulley (#36) to the open slot on the Left Lat Bar Frame (#10). Secure it with one
M10 x 2 1/8” Allen Bolt (#57), two Pulley Bushings (#41), and one M10 Aircraft Nut (#66).
Repeat the same procedure to install the other side.
F.) Attach a Pulley to the bracket on the Lat Bar Frame Bracket (#20). Secure it with one
M10 x 1 ¾” Allen Bolt (#58), two Ø ¾” Washers (#64), and one M10 Aircraft Nut (#66).
G.) Insert the Right & Left Bar Catches (#16 & 18), Right & Left Safety Catches (#17 & 19)
into the selected holes on the Upright Beams to obtain the desired position.
9