Filter
Top Products
STEP 4 (See Diagram 4)
A.) Attach two Ø ¾” Leg Developer Bushings (#19) to the Leg Developer (#10). Attach the
Leg Developer to the Front Post (#9). Secure it with one M10 x 3 1/8” Allen Bolt (#35), two
Ø ¾” Washers (#40), and one M10 Aircraft Nut (#31). Do not over tighten the Nut and
Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert two Foam Tubes (#17) halfway through the holes on the Leg Developer. Push four
Foam Rolls (#20) onto the Tubes from both ends. Plug four Foam Roll End Caps (#29)
into the ends.
C.) Attach a Spring Clip (#18) onto the weight post on the Leg Developer.
DIAGRAM 4
10