Filter
Top Products
ASSEMBLY INSTRUCTION
Tools required assembling the machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended two or more people assembling this
machine to avoid possible injury.
STEP 1 (SEE DIAGRAM 1)
A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#2) in the Mid-span.
Secure each end of Cross Brace with two M10 x 3 1/8” Hex Bolts (#40), four ∅ ¾”
Washers (#48), one Bracket (#17), and two M10 Aircraft Nuts (#51).
B.) Insert the Backrest Adjustment Bar (#9) through a selected hole to obtain desired incline
of Backrest.
C.) Insert Left & Right Bar Catches (#11) & (#12) into the selected holes on the Rear Upright
Beams to obtain the desired height to hold the weight bar.
DIAGRAM 1
5