Filter
Top Products
8
STEP 5 (SEE Diagram 5)
A.) Attach the ball end of the Cable (#38) to the Pulley (#36). Place the Pulley in the open slot
on the Lat Bar Frame (#15). Secure the Pulley with one M10 x 2 1/8” Hex Bolt (#41), two
Bushings (#37), and one M10 Aircraft Nut (#51).
B.) Slide the Weight Holder (#13) onto the Lat Bar Frame from the bottom. Connect the Cable
to the Holder with a Hook (#22). Attach a Spring Clip (#21) onto the post on the Weight
Holder.
C.) Connect the Lat Bar (#16) to the Cable with a Hook (#22). When using the Lat Pull Down,
remove the Arm Curl and place it on the storage post behind the Rear Upright Beam.
Then insert the Lat Bar Frame into the opening on the Front Stabilizer and use the Lock
Knob (#24) to hold it in position.