Filter
Top Products
COMPUTER INSTRUCTION MANUAL
A. POWER UP:
1. Install four UM-2 or R14 batteries into the battery case on the back of monitor.
Batteries must be installed in sequence and be correctly positioned according to the
polarity.
2. If the power source is lower than 2.6V, the low battery indicator on the screen will
remind you to replace with new batteries.
3. After power up, all LCD segments will light up for 2 seconds. The CPU will reset the
resistance level to 0 and then set the system into the initial mode.
REMARK:
1. If the connection cables were installed incorrectly, the monitor will display "E" and
generate a beep sound. Check all the connections then turn on the power switch again
to reset the power and release the beep sound.
2. After using a period of time, if the power source cannot drive smoothly, the monitor will
display a sigh of "E". Please take out the batteries and wait for 15 seconds, then
re-install them. If the monitor still presents "E" & beeps, please call customer service.
B. KEY BOARD:
＋
＋＋
＋ : Selects program or set up the values of load level, time & age.
－
－－
－ : Selects program or set down the values of load level, time & age.
ENTER : During STOP mode, press ENTER key to enter time or age setting.
START / STOP : To start or stop exercise.
Hold this button for 2 seconds can enter initial & reset all values to 0.
C. FUNCTIONS:
This system contains 12 different programs. The workout time can be preset and the system will
divide the time by 10 intervals. If you do not preset the workout time, the system will count up
theworkout time by one-second increment.
11