Filter
Top Products
Insert the Barbell (35) through the locking Bar (34)
until the Barbell Is centered in the Locking Bar.
9.
Identify the Left Weight Glider (32) by looking at the
position of the round tube.
Press a 38ram Bushing (29) into each end of the
round tube on the Left Weight Glider (32).
Slide the Left Weight Glider (32) onto the left end of
the Barbell (35). Secure the Weight Glider to the
Barbell with a hand-tightened M8 x 16mm Screw (50).
Look at the drawing on page 4 to make sure that
you have correctly identified the left end. The Left
Weight Glider must be turned as shown in the
drawing.
9
35
29
32
Round tube
5O
29
10. Identify the Right Weight Glider (31) by looking at the
position of the round tube.
Press a 38mm Bushing (29) into each end of the
welded tube on the Right Weight Glider (31).
Slide the Right Weight Glider (31) onto the right end
of the Barbell (35). Secure the Weight Glider to the
Barbell with a hand-tightened M8 x 16mm Screw (50).
Make sure that the Weight Glider is turned as
shown in the drawing.
11. Note: If you are not planning to use Olympic weights
with the weight bench, you do not need to perform
this step. Keep the two Weight Adapters (33) in a
safe place in case you need them in the future.
Slide a Weight Adapter (33) onto one end of the
Barbell (35). Using the allen wrench, secure the
Weight Adapter with an MIO x 25mm Bolt (43) and a
Large Washer (44). Note: The Large Washer must
fit into the indentation in the 50ram Bushing (47)
in the Weight Adapter.
Attach the other Weight Adapter (33) to the other end
of the Barbell (35) in the same manner•
10
o
11
35
33
47
44/ /"
43
9