Filter
Top Products
Left Safety Spotteris positioned as shown,thehandle.
willpoint towardthe center of the bench.
Place the Left Safety Spotter (24) on the left Base (7)
so it is centered over the indicated hole.
Have a second person hold the Locking Bar (34) so
that the Left Weight Glider (32) rests on top of the
Left Safety Spotter (24)..Insert a Weight Guide (18)
into the Left Weight Glider, the Left Safety Spotter,
and the hole in the Base (7). Note: It may be neces-
sery to tilt the Weight Guide away from the
Upright (1) as you insert it.
Attach the Weight Guide (18) to the Base (7) with an
M8 x 60ram Bolt (39), two M8 Washers (52), and an
M8 Nylon Locknut (54). Do not tighten the Nylon
Locknut yet.
13. Place the Right Safety Spotter (23) on the right Base
(7) and center it over the indicated hole. Note: The
handle must point toward the center of the bench.
Have a second person holdthe Locking Ba_ (34) so
that the Right Weight Glider (31) rests on top of the
Right Safety Spotter (23). Insert a Weight Guide (18)
into the Right WeightGlider, the Right Safety Spotter,
and the hole in the Base (7). Note: It may be neces-
sary to tilt the Weight Guide away from the
Upright (1) as you insert it.
Attach the Weight Guide (18) to the Base (7) with an
M8 x 60mm Bolt (39), two M8 Washers (52), and an
M8 Nylon Locknut (54). Do not t!ghten the Nylon
Locknut yet.
14. Attach the upper end of one of the Weight Guides
(18) to the bracket on the Upright (1) with an M8 x
30mrfi Belt (38) and an MB Washer (52).
Attach the other Weight Guide (18) to the other
Upright (1) in the same manner.
Tighten the M8 x 16ram Screws (50) used in steps
9to 10.
Tighten all of the Nylon Locknuts used in steps 1
to 14.
34
13
Hole
52 39
39 23\
18--- 1
10 _"