Filter
Top Products
11 i//_r 5 "
Attach the Small Stabilizer (25) to the Bench Frame •.. A I 11- - "
(5) with two M10 x 65mm Cardage Bolts (40) and two "_A #'-"_.']'!I
M10 Nylon Locknuts (11). Note: There is an inden- _ _'1 iI
tation around the holes on one side of the Small '4f "--_F_._,<4_>
Stabilizer. This side must be facing the floor. _._'_'_"_ 25
40J_J
16. Press a 50mm x 70mm Outer Cap (10) onto each
end of the Large Stabilizer (26).
Turn the Large Stabilizer (26) so the warning decal is
in the position shown. Attach the Large Stabilizer to
the Bench Frame (5) with two M10 x 65ram Carriage
Bolts (40) and two M10 Nylon Locknuts (11). Note:
There is an indentation around the holes on one
side of the Large Stabilizer. This side must be fac-
ing the floor.
17. Press two 20mm x 40ram Inner Caps (28) into each
Backrest Tube (27). Press four 20mm x 40ram Inner
Caps into the Backrest Adjustment Bracket (36).
Lubricate an MIO x 180mm Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Backrest Adjustment Bracket (36) with the Bolt, two
M10 Washers (6), and an M10 Nylon Locknut (11).
Make sure that the Backrest Tubes are turned as
shown. The indicated holes are not centered in
the Backrest Tubes but are closer to one side.
Turn the Backrest Tubes so the holes are closer
to the floor. Do not overtighten the Nylon Locknut;
the Backrest Tubes must pivot easily.
18. Attach the Backrest Adjustment Bracket (36) to the
bracket on the Bench Frame (5) in the following way:
Lubricate an M10 x 115mm Bolt (55). Slide an M10
Washer (6) onto the Bolt and insert the Bolt through
the indicated tube of the Backrest Adjustment Bracket
(36).
Hold the Backrest Adjustment Bracket (36) over the
bracket on the Bench Frame (5). Insert the Bolt
through one side o1 the bracket. Slide the 15mm x
10.2mm x 60mm Spacer (57) onto the Bolt. Next,
insert the Bolt through the other side of the bracket
and the other tube of the Backrest Adjustment
Bracket. Secure the Bolt with an M10 Washer (6) and
an M10 Nylon Locknut (11). Do not overtighten the
Nylon Locknut.
16
Decal
40
17 Lubricate
22_ \ 6
28
27 28
Wel
Tube 36
18 27
55
Lubricate
36
10
11